BY701-Firmware: Synchronization of Drives
in combination with Motion Controller MC700
The BY701 firmware is suitable for applications where either angle-synchronous synchronisation of drives (electronic shaft) or variable ratio (electronic transmission) is required. A short position control (< 1 ms) as well as intelligent calculation algorithms ensure the highest precision in all synchronous phases. A controller of type MC700 can operate up to 4 axes. Excellent functions for modifying synchronous ratios and phase position are available at standstill and during operation. Index and print mark signals can also be evaluated.
- MC700 is a universal motion controller for 1 to 4 axes, which can be assigned any motion control functions by loading a firmware. Together with the firmware BY701 (see firmware), this controller offers excellent synchronous functions for 1 - 4 axes.
- The firmware offers all conceivable possibilities for the synchronization of drives, including the influence of phase position and relative position between the drives and numerous index and print mark functions.
- Optionally, a "physical master" or the built-in "virtual master axis" with programmable speeds and ramps can be used as master drive.
- The number of successive axes can be extended arbitrarily via a cascading output.
- MC700 controllers can be operated via an external control terminal, serial interface or optional via CANBUS (MC700/CI). PC operator software is included.
- PROFIBUS connection possible via gateway PB251 (see accessories)
File type: pdf, File size: 951 KB
File type: pdf, File size: 479 KB
Data Sheet MC700
File type: pdf, File size: 206 KB
CAN-Bus
EDS Files for CANopen© units MC700 / CA307 / CA340 / CA541.
Synchronization of Drives for MC700
With the use of BY701 firmware, the MC700 controller provides excellent solutions with all kinds of multi-axes synchronizing applications. Numerous possibilities for control of relative phase, position, index and print mark evaluation are available.
« Back to overview