FS801-Firmware: Flying Material Processing

in combination with Motion Controller MC800

The MC800 multi-axis motion controller, a successor to the proven MC700, impresses with its even higher bandwidth and an even more flexible bus architecture. A special highlight of this drive control is the integrated Tandem Drive Controller. That allows to achieve the acceleration requirement of a secondary axis by means of power distribution on two independent drives.
 

  • 2 pulse inputs with format  A, /A, B, /B, Z, /Z [HTL, RS422]
    with an input frequency up to 2 MHz
  • 2 control inputs with format  SIN+, SIN-, COS+, COS- [1 Vss]
    with an input frequency up to 400 kHz
  • 2 SSI inputs with format  DATA+, DATA-, CLOCK+, CLOCK-
    up to 25 Bit, with SSI switching frequency of 100 Hz ... 1 MHz
  • 2 scalable 14 bit analog inputs for ±10 V or 0/4 ... 20 mA
  • 4 control inputs for PNP / NPN signals [10 ... 30 VDC]
  • 4 fast interrupt inputs for PNP / NPN signals [10 ... 30 VDC]
  • 1 pulse output with format  A, /A, B, /B, Z, /Z [RS422]
  • 4 control outputs with push-pull characteristic, short-circuit-proof [5 ... 30 VDC]
  • 2 scalable 14 bit analog outputs for ±10 V or 0/4 ... 20 mA
  • Loop time approx. 250 µs
  • Power supply 18 ... 35 VDC
  • Snap-on housing for top hat rail (according to EN 60715)
  • OnBoard interfaces: Ethernet / IP, RS232 / RS485, USB 2.0, CANopen, Modbus RTU
  • Optional Ethernet interfaces: EtherCAT, Ethernet / IP, Modbus TCP, Powerlink, PROFINET, SERCOS III
  • Optional Fieldbus interfaces (slave): CC-Link, DeviceNet, PROFIBUS
  • Operates with all 4-Q-drive systems, equipped with a standardized drive communication bus (e. g. SERCOS-II). Alternatively ±10 V setpoint can be used
  • The controllers can be setup by an external operator terminal as well as HMI’s via standardized factory communication bus e. g. PROFINET
  • Setup via windows operator software (free of charge

 

Manual FS801

File type: pdf, File size: 2 MB

Manual MC800

File type: pdf, File size: 287 KB

Data Sheet MC800

File type: pdf, File size: 140 KB

PROFIBUS (MC800)

PROFIBUS© GSD File for motrona MC800 units.

HMSB1811.zip (2 KB)

(available with login)

Flying Material Processing for MC800

By using this application firmware, the MC800 controller is equipped for motion control tasks with typical “on-the-fly-processing” machines (e. g. sawing, cutting, punching, drilling, etc.).

The FS801 has an additional axis. This allows for example the controlling of the saw carriage and additionally the saw blade at the same time.

Compared to the FS701 firmware, a significantly higher dynamic is achieved by using the combination FS801 firmware with MC800. In addition, processing to various sensor systems and fieldbus architectures is possible.

License code on demand.


« Back to overview